Sunday, January 18, 2015

42G-03 Comm Radio/Intercom

It doesn’t look like much, but some work was involved in putting in the radio. You may recall that I spent a few hours filing the rectangular opening to ensure that the radio would fit through it properly, which I was able to accomplish.  On the bench.  After I attached the radio supports and mounts, I discovered that the radio sits on a shelf that lifts it about 2 mm relative to the front panel.  This meant that I had to takeout the recently installed switch module and remove the center panel and spend another hour with a dremel tool and flat file to open up the hole another 2 mm.  <sigh>

IMG 3918

No comments:

Post a Comment